Information about sleeping mats

 

SAFETY

Intended use

This product is designed exclusively as a sleeping mat for private camping and outdoor use. The permissible load is 120 kg. The product may only be filled with air. The maximum permissible operating pressure is 0,03 bar. Use the product only as described in these instructions.

Any other use is considered improper and may result in property damage or even personal injury. This product is not a toy. The manufacturer or retailer assumes no liability for damage caused by improper or incorrect use.

safety instructions

WARNING! Danger of drowning! Warning: Not suitable for swimming!

Use

Further information General instructions for use

Improper handling of the product can lead to damage. Only inflate the product with air by manually inflating it or using a suitable air pump. Do not use pre-compressed air from cartridges or compressors. Keep the product away from sharp or pointed objects or jagged edges. A sturdy tarpaulin as an additional base is recommended. Use the product only on easily accessible, level, and sufficiently stable surfaces.

Do not expose the product to high temperatures (heaters, open flames, etc.) and keep it away from hot surfaces (e.g., barbecues). Do not expose the product to extreme weather conditions (rain, hail, etc.). Distribute loads as widely and evenly as possible across the product. IMPORTANT: Air expands in the sun or in hot rooms. Do not leave the product unattended in these areas and release the air if necessary.

USE

  • Roll out and inflate

  • Clean the installation site of stones and other pointed or sharp-edged objects.

  • Remove the protective cover and unfold the product completely.

  • Open the valve and fill the product with air, using the bag as a bellows. Observe the maximum permissible Operating pressure if you use an air pump.

  • The mat can be inflated to a maximum height of 9 cm. A LAir volume exceeding this does not constitute a proper solution. Use of the mat.

  • Close the valve carefully.

  • Vent and roll up

  • Clean the product of coarse dirt, stones and other pointed or sharp-edged objects.

  • Open the valve and let the air escape. Wait until the product is fully vented.

  • Fold the product lengthwise and roll it up from the opposite side of the valve. Roll slowly to completely expel any remaining air from the product.

  • Store the product in the protective case.

  • If your air cell mat has a leak through a hole, you can You can repair it with a standard nylon repair kit. Repair the damage as instructed by the repair kit manufacturer. If this doesn't work, the air-cell mat must be discarded.

Cleaning and storage
Improper cleaning and storage can cause damage to the product or mold growth. Clean and dry the product thoroughly after each use. Do not use aggressive cleaning agents. Do not use sharp or metallic objects such as knives, hard spatulas, or hard cleaning brushes. Rinse the product surface with clean water. Remove stubborn dirt with lukewarm water and a soft, clean sponge. Dry the product with a soft, absorbent cloth. Allow any residual moisture to dry completely before rerolling.